iei 212i keypad programming instructions

IEI 212I KEYPAD PROGRAMMING INSTRUCTIONS CODE
IEI 212I KEYPAD PROGRAMMING INSTRUCTIONS SERIES
IEI 212I KEYPAD PROGRAMMING INSTRUCTIONS FREE

IEI 212I KEYPAD PROGRAMMING INSTRUCTIONS CODE

The Master Code is always assigned to user location one (1). Codes may be from 1-6 digits in length and digits may be repeated. CODES The Door-Gard Command and Control keypads allow up to 120 individual user codes to be valid. LED or Sounder guidance makes programming easy, and changing codes a matter of seconds for an authorized user. PROGRAMMING All programming is accomplished entirely from the front of the keypad. FEATURES: 4 INDEPENDENT OUTPUTS 4 INDEPENDENT TIMERS ALL OUTPUTS ASSIGNABLE BY CODE ON BOARD 8 AMP FORM C RELAY 120 USERS REMOTE TRIGGERING INPUT KEYPAD PROGRAMMABLE MEMORY Non-volatile EEPROM memory means your codes and instructions will be there whether you remove power for 5 minutes or 5 years. Door-Gards accept power from a 12 or 24V AC/DC Supply.

IEI 212I KEYPAD PROGRAMMING INSTRUCTIONS SERIES

Designed for individual control of up to four devices, Door-Gard Command and Control Series keypads are the perfect choice for controlling electric locking devices, security systems, automatic operators or machinery.

This warranty shall expire two years after shipping date for DOOR-GARD keypads.Įxcept as stated above, IEI makes no warranties, either express or implied, as to any matter whatsoever, including, without limitation to, the condition of its products, their merchantability, or fitness for any particular purpose.1 FEATURES AND PROGRAMMING GUIDE COMMANDANDCONTROLSERIES DOOR-GARD COMMAND AND CONTROL SERIESkeypads offer field proven reliability and cost effective solutions anywhere limited control or access is desired.

IEI will not be liable to the purchaser or anyone else for incidental or consequential damages arising from any defect in, or malfunction of, its products. IEI’s sole liability is limited to the repair or (at IEI’s option) the replacement of the defective product or part when sent to IEI’s facility (freight and insurance charges prepaid), after first obtaining IEI’s Return Merchandise Authorization.

IEI does not assume any responsibility for damage or injury to person or property due to improper care, storage, handling, abuse, misuse, normal wear and tear, or an act of God.

IEI 212I KEYPAD PROGRAMMING INSTRUCTIONS FREE

(IEI) warrants its products to be free from defects in material and workmanship, when they have been installed in accordance with the manufacturer’s instructions, and have not been modified or tampered with.

On SE keypad, holes have also been spotted inside the front housing for additional LEDs (LEDs not included).

To speed installation of the SE keypad, holes have been spotted on the inside the back housing for mounting to a wall or a single-gang electrical box.

For use in extreme weather conditions, consult the factory for additional methods of protecting your keypad.

This allows air to circulate and a place for condensation to drain.

Do not seal the drain holes at the bottom of the keypad housing.

Do not silicone the cover plate because the unit will not seal properly. This helps prevent water from entering the case and condensing on the circuit board.

When mounting this unit outside, apply silicone to the area where the wires enter the case.

The bi-color LED provided with the SE keypad illuminates red when the LockRelease relay is de-energized and green when the relay is de-energized.

To avoid ESD (Electro-Static Discharge) interfering with the operation of the keypad, ground the housing to earth ground.

Iei 212i keypad programming instructions